Ge-industrial-solutions EntelliGuard G Coil Signaling Contacts Manuel d'utilisateur télécharger pdf

Introduction

Coil Signaling Contacts:

Coil Signaling Contacts indicate the status of the

coil they are installed on. Coil Signaling Contacts

consists of two switches thus enables the status

of the coils thru trip unit and the secondary

disconnect. Status switch thru secondary

disconnect can be power rated or signal rated.

Status switch thru trip unit is a signal rated.

Table 1. Catalog Number and Ratings:

CSC, Power rated Contact:

Cat no

125Vdc 6A

AC Ratings

250Vdc 6A

GCSP1R

DEH-41420 Installation Instructions

EntelliGuard

G Circuit Breaker

Accessories

Coil Signaling Contacts

WARNING: Before installing any accessories, turn the

breaker OFF, disconnect it from all voltage sources,

and discharge the closing spings.

CSC, Signal rated Contact:

Cat no

AC Ratings 125Vac 0.1A

DC Ratings 30Vdc 0.1A

GCSP2R

Use the following procedure to install Release

Indication Contact accessory into the circuit

breaker.

1. Verify that the rating on the Release Indication

Contact identification plate matches the voltage

rating required for the application, as listed in

Table 1.

2. Turn the breaker off and discharge the closing

springs by depressing the OFF and ON buttons in

the sequence OFF-ON-OFF. Verify that the

breaker OFF-ON indicator shows OFF on a green

background and that the charge indicator shows

DISCHARGE on a white background. If installing

in a draw-out type breaker remove breaker from

adaptor (cassette) before continuing.

AVERTISSEMENT: Avant d’installer tout accessoire,

mettre le disjoncteur en position OFF, le déconnecter

de toute tension d’alimentation , et décharger les

resorts d’armement

3. Loosen the 6 screws on front cover (fascia)

using a posidrive screw driver as shown in Fig 1.B

1 2 3 4

Résumé du contenu

Page 1

Introduction Coil Signaling Contacts: Coil Signaling Contacts indicate the status of the coil they are installed on. Coil Signal

Page 2

Rotate the charging handle down and slide the front cover over the handle to remove the front cover as shown in Fig. 1.C. Figure 1. (A) Front Cove

Page 3

Figure 6. Assembly of connector 7. Tilt the device backwards until the rear hooks engage in the slots on the mechan

Page 4

Reference: These instructions do not purport to cover all details or variations in equipment nor,

Commentaires sur ces manuels

Pas de commentaire

Ge-industrial-solutions EntelliGuard G Coil Signaling Contacts Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Ge-industrial-solutions EntelliGuard G Coil Signaling Contacts. GE Industrial Solutions EntelliGuard G Coil Signaling Contacts User Manual [de] [fr] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Ge-industrial-solutions EntelliGuard G Coil Signaling Contacts