Ge-industrial-solutions EntelliGuard G Motor Operator Manuel d'utilisateur télécharger pdf

Motor Operator

The unique motor/gearbox unit is specially

designed to operate with the full range of

EntelliGuard G Circuit Breakers. It is easily fitted

with three heavy-duty bolts. After a breaker close

operation, the unit automatically recharges the

spring and makes it ready for immediate open

and re-close should the need arise. High speed

recharging ensures that the springs are fully

charged within approximately three seconds

following a release. All electrically operated (EO)

ANSI/UL breakers are equipped with “Spring

Charged, Power Rated” contacts for status

indication.

Table 1. Motor Catalog and Ratings

Envelope

Size

Catalog #

Voltage

Rating

GM01024D 24/30Vdc

GM01048D 48 Vdc

GM01060D 60Vdc

GM01110D 110/130 Vdc

GM01250D 250 Vdc

GM01048A 48 Vac

GM01120A 120 Vac

GM01240A 240 Vac

Envelope

GM01277A 277 Vac

GM02024D 24 /30 Vdc

GM02048D 48 Vdc

GM02060D 60 Vdc

GM02110D 110/130 Vdc

GM02250D 250 Vdc

GM02048A 48 Vac

GM02120A 120 Vac

GM02240A 240 Vac

Envelope

GM02277A 277 Vac

EntelliGuard

G Circuit Breaker

Accessories

Motor Operator

WARNING: Before installing any accessories, turn the

breaker OFF, disconnect it from all voltage sources,

and discharge the closing spings.

• Duty Cycle = 2/min

• Spring Charge time = 4s max

• Frame 1 motors: running ~300VA

• Frame 2/3 motors: running ~450VA

• Inrush is 2 to 3 times running VA

Use the following procedure to install the Motor

Operator accessory into the circuit breaker.

1. Verify that the rating on the Motor Operator

Mechanism identification plate matches the

voltage rating required for the application, as

listed in Table 1.

2. Check that the package contains all the parts

listed in Table 2. If any components are missing,

contact the Electrical Distribution Post Sales

Service Team at 1-800-843-3742.

Table 2. Parts List

Description Quantity

Motor Operator Assembly 1

Shaft Bearing Sleeve 1

Switch Operating Cam 1

Washer M8 1

Nylock Nut M8 1

Cerrated Belleville Washer M5 3

Hex Socket Head Cap Screw M5X30 3

AVERTISSEMENT: Avant d’installer tout accessoire,

mettre le disjoncteur en position OFF, le déconnecter

de toute tension d’alimentation , et décharger les

resorts d’armement

DEH-41413 Installation Instructions

1 2 3 4

Résumé du contenu

Page 1 - Motor Operator

.Motor Operator The unique motor/gearbox unit is specially designed to operate with the full range of EntelliGuard G Circuit Breakers. It is easily fi

Page 2

3. Turn the breaker off and discharge the closingsprings by depressing the OFF and ON buttons in the sequence OFF-ON-OFF. Verify that the breaker OFF

Page 3 - Figure 7. Assembly of Nut

12. To reinstall the cover, rotate the charginghandle down and slide the front cover over the handle to assemble the front cover to housing as shown i

Page 4 - Reference:

Reference: Secondary Disconnect Wiring Diagram These instructions do not purport to cover all details or variations in equipment nor, to provide con