Ge-industrial-solutions EntelliGuard G Key Interlock Kit Manuel d'utilisateur télécharger pdf

Introduction

Key Interlock Kit:

The breaker key lock is an optional accessory,

which will keep the breaker in trip free state while

locked. Maximum 4 keys of Ronis/Profalux or Kirk

type can be used. All EntelliGuard Devices can be

equipped with one of the three locks, that when

fitted as indicated allow the use of one to four key

locks that lock the device in its open position.

Figure 1. (A) Front Cover

Devices are found in two Variants:

1. Factory mounted mechanism:

The breaker/device is supplied off works with all

cams and screws allowing the user to mount a

separately acquired GE type lock kit.

2. Field mountable device:

A kit is supplied allowing the field mounting of the

locking mechanism and allowing the use of a lock

of the correct type purchased elsewhere

Catalog Number:

Catalog No Description

GBKRKR Kirk Key Interlock kit

GBRONR Ronis Interlock kit

GBPROR Profalux Interlock kit

Use the following procedure to install the Key

Interlock Key accessory into the circuit breaker.

1. Turn the breaker off and discharge the closing

springs by depressing the OFF and ON buttons in

the sequence OFF-ON-OFF. Verify that the

breaker OFF-ON indicator shows OFF and that the

charge indicator shows DISCHARGE. If installing

in a draw-out type breaker remove breaker from

adaptor (cassette) before continuing.

2. Loosen the 6 screws on front cover (fascia)

using a posidrive screw driver as shown in Fig 1.B

EntelliGuard

G Circuit Breaker

Accessories

Key Interlock Kit Breaker Mounted

WARNING: Before installing any accessories, turn

the breaker OFF, disconnect it from all voltage

sources, and discharge the closing spings.

AVERTISSEMENT: Avant d’installer tout accessoire,

mettre le disjoncteur en position OFF, le

déconnecter de toute tension d’alimentation , et

décharger les resorts d’armement

DEH-41407 Installation Instructions

1 2 3 4

Résumé du contenu

Page 1

Introduction Key Interlock Kit: The breaker key lock is an optional accessory, which will keep the breaker in trip free state whi

Page 2

Rotate the charging handle down and slide the front cover over the handle to remove the front cover as shown in Fig. 1.C. Figure 1. (B) Screw Remov

Page 3

8. If the locking mechanism device has been supplied factory fitted. Remount the mechanism with its cover into the breaker, making sure that the opera

Page 4

10. To reinstall the cover, rotate the charging handle down and slide the front cover over the handle to assemble the front cover to housing as show

Commentaires sur ces manuels

Pas de commentaire

Ge-industrial-solutions EntelliGuard G Key Interlock Kit Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Ge-industrial-solutions EntelliGuard G Key Interlock Kit. GE Industrial Solutions EntelliGuard G Key Interlock Kit User Manual [en] [de] [fr] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Ge-industrial-solutions EntelliGuard G Key Interlock Kit