g
Spectra Series™ Power Panelboards
Type AMB Main Lug Kit
Application
These instructions apply to main lug kits with the
following catalog numbers:
AMB2600MA AMB3600MA AMB2600MC
AMB3600MC AMB2120MA AMB3120MA
AMB2120MA AMB3120MC AMB2120DMC
AMB3120DMC AMB2120DMA AMB3120DMA
Installation
WARNING: Dan
er of electrical shock or in
ur
.
Turn
OFF
ower ahead of the
anelboard or
switchboard before workin
inside the
e
ui
ment or removin
an
com
onent.
E
ui
ment is to be installed and maintained b
properly trained and qualified personnel only.
1. Orient the lug base with the lug wire holes facing the
end of the box marked
LINE. For catalog numbers
AMB2120MA, AMB3120MA, AMB2120MC,
AMB3120MC, AMB2120DMC, AMB3120DMC,
AMB2120DMA, and AMB3120DMA, feed the lug
tangs through the support, as shown in Figure 1.
Catalog numbers AMB2600MA, AMB3600MA,
AMB2600MC, and AMB3600MC do not contain this
support.
CAUTION: Failure to
ro
erl
insert the lu
tan
in the su
ort for the re
uired kits will
cause destructive behavior durin
short-circuit
conditions.
Figure 1. Lug tang inserted into the support.
2. Locate the mounting position. For Spectra APNB bolt-
on style interiors, locate the side of the panelboard
interior in which the dimension from the nearest bus
face to the inner face of the bus support rail is 2.75
inches, as shown in Figure 2. Lug tangs will be
mounted on this side of each phase of the bus.
Figure 2. Lug tang position relative to the bus bars of a Spectra
APNB bolt-on interior.
For Spectra APN plug-in style interiors, the lug tangs
are positioned between the buses for each phase, as
shown in Figure 3. For Spectra APN interiors, rated at
600 A or less, the lug tangs are positioned as described
above for Spectra APNB interiors.
Figure 3. Lug tang position relative to the bus bars of a Spectra APN
plug-in interior.
WARNING: Positionin
the lu
s correctl
relative to the bus bars is crucial to
roduct
safet
and if installed im
ro
erl
will result in
electrical shock or injury.
3. Align the mounting holes. Align the lug tang
mounting holes with the first and second bus holes
from the box end stamped
LINE on the rear row of
holes, as shown in Figure 4.
DEH070 Installation Instructions R02
Lug
Tang
Bus
Carriage
Bolt
Conical
Washer
Nut
Lug
Tang
Bus
Carriage
Bolt
Conical
Washer
Nut
Commentaires sur ces manuels