Ge-industrial-solutions Power Mark Gold Load Centers Manuel d'utilisateur télécharger pdf

DEH

40537 Installation Instructions

For

100-225 Ampere Single Phase 12-42 Circuit

PowerMark Gold ™Load Center

Indoor Type

General

To comply with the National Electrical Code and

Underwriters Laboratories, the load center must be

installed in accordance with the information included on

the label on the inside of the equipment. This must also

be done in accordance with applicable local electrical

codes, and by a qualified electrical contractor and/or

licensed electrician.

WARNING: Hazard of electrical shock or burn. Turn off

power before working inside this equipment.

1. Remove Front

Slip front and accessory package back into carton to

protect finish.

2. Remove Interior (optional)

3. Mount Box

For Flush Mount line up front box

edge with finish wall surface and

screw or nail to stud through small

KO’s in box side. For Surface Mount

screw or nail through keyhole slot in

back of box.

TOP OR BOTTOM FEED

The load center will easily accommodate incoming

electrical service from the top or bottom. Rotate the entire

load center enclosure if a bottom feed configuration is

required.

4. Remove KO’S for all main and branch

circuits.

Knockout Center

KO inward then

Outer Rings

First knock center KO inward. Outer rings should be

alternately pried up or driven in one at a time.

5. Pull incoming service and branch circuit

wiring into box.

6. Replace interior

Reinstall mounting screws removed in Step 2.

Back Out

Mounting

Screws and

save for reuse.

(Both sides)

Slide Interior

Up to clear

tabs and

remove.

7. Wire main, neutral, and equipment

ground.

Refer to rating label inside equipment for proper

tightening torque. Wire neutral and equipment ground

only in direction indicated by arrows. If required, ground

and bond neutral to box using screw provided.

Equipment

Ground

Neutral

eutral

Nail or

Screw

8. Optional wiring of neutral and ground

The neutral crossbar may be removed to provide optional

neutral and ground wiring as follows:

1 2 3 4

Résumé du contenu

Page 1 - Indoor Type

DEH - 40537 Installation Instructions For 100-225 Ampere Single Phase 12-42 Circuit g PowerMark Gold ™Load CentersIndoor Type General To comp

Page 2 - GE Consumer & Industrial

Right or left side Main Breaker Service Entrance with Bonding Screw Main Lug Only without Bonding Screw Uninsulated neutral or ground Insulated neut

Page 3 - Para interiores

General Para cumplir con el Código Eléctrico Nacional (National Electrical Code) y los Laboratorios Aseguradores (Underwriters Laboratories), e

Page 4

8. Cableado opcional del neutro y de la conexión a tierra La barra del neutro puede retirarse para ofrece un cableado opcional del neutro y de la con

Commentaires sur ces manuels

Pas de commentaire

Ge-industrial-solutions Power Mark Gold Load Centers Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Ge-industrial-solutions Power Mark Gold Load Centers. GE Industrial Solutions Power Mark Gold Load Centers User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Ge-industrial-solutions Power Mark Gold Load Centers