g
Spectra Series™ Power Panelboards
Type AFP Filler Plates
WARNING: Dan
er of electrical shock or in
ur
.
Turn
OFF
ower ahead of the
anelboard or
switchboard before workin
inside the
e
ui
ment or removin
an
com
onent. Do
not remove circuit
rotective devices or an
other com
onent until the
ower is turned
OFF.
Installing the Filler Plates
Use the following procedure to install type AFP filler
plates. The catalog numbers covered by this instruction
are listed in Table 1.
Catalog
Number Use with ADS Switch
Box
Width, in.
AFP10T
400 A & 600 A J or T fuse, 10X main
or branch
36, 44
AFP10X
400 A & 600 A R fuse, 10 X main or
branch
44
AFP19X 800 A & 1200 A, 19X main or branch 44
AFP4X 30 A & 60 A, 4X 44
AFP5X 60 A & 100 A, 5X 44
AFP7T 100 A & 200 A T fuse, 7X 44
AFP7X2 200 A R fuse, 7X double branch 44
AFP7X
200 A R fuse, 7X main or single
branch
36, 44
Table 1. Type AFP filler plates covered by this instruction.
1. For ease of assembly, the filler plates should be
installed after the side trim is in place.
2. Insert the flat end of the filler plate into the channel
on the edge of the side trim, as shown in Figure 1.
Figure 1. Inserting the filler plate into the side trim.
3. Attach the opposite end of the filler plate to the
flange on the device, using the screws furnished on
the filler plate, as shown in Figure 2. Tighten the
screws to 25–30 in-lb.
Figure 2. Attaching the filler plate to the device.
GE Industrial Systems
General Electric Company
41 Woodford Ave., Plainville, CT 06062
GEH5590 R03 0701 © 2001 General Electric Company
These instructions do not cover all details or variations in e
ui
ment nor do the
rovide for ever
ossible contin
enc
that
ma
be met in connection with installation, o
eration, or maintenance. Should further information be desired or should
articular
roblems arise that are not covered sufficientl
for the
urchaser’s
ur
oses, the matter should be referred to the
GE Company.
GEH5590 Installation Instructions R03
Side Trim
Filler Plate
Screw
Commentaires sur ces manuels