Ge-industrial-solutions HE300GEN251 Manuel d'utilisateur télécharger pdf (Page 44)

CH. 8: INSTALLATION 23 SEP 1999 PAGE 45

8.2.7 Re-assembly

a. Mount the regulator card with the GEN250 attached on the four standoffs with four screws. (See

Figure 8.4.)

b. Reconnect the ribbon cable between the lower power card and the regulation card. (See Figure 8.2.)

c. Replace the housing by sliding the housing tabs into the recess and slide downward until the points at

the lower end are engaged over pins.

d. Reconnect the four plugs that were removed during disassembly. Connect the two wires from the

GEN250 to points #18 and #19 (Figure 8.5).

SNAP TWO STANDOFFS

INTO REGULATION CARD

ATTACHMENT OF PCB TO REGULATION CARD

INSTALL POWER CABLE

INTO TERMINAL 18 & 19

STEP 2

INSTALL TWO

SCREWS

INSTALL JUMPER CABLE

Figure 8.3 – Installing GEN250

Figure 8.4 – Installing GEN250

STANDOFFS INTO BOARD

SNAP TWO PLASTIC

STEP 1

SCREW TWO STANDOFFS

INTO BOARD

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51

Pas de commentaire

Ge-industrial-solutions HE300GEN251 Manuel d'utilisateur Page 44