Ge-industrial-solutions A Series Lighting Control Panelboards Installation Manuel d'utilisateur télécharger pdf

DEH41081 Installation Instructions R02

A Series

Lighting Control Panelboards

Introduction

These instructions describe the installation of a AE

Series lighting control panel interior with internally

mounted as well as externally mounted controller.

Installation

WARNING: Danger of electrical shock or

injury. Turn OFF power service to the line side

of the panel board or switchboard before

working inside the equipment or removing

any component

. Equipment is to be installed

and maintained by properly trained and

qualified personnel only.

- 1 -

1. Confirm the contents and circuit layout of the

panel Interior and mounting hardware. Figure 1

illustrates the parts included in this panel Interior,

which are listed in Figure 1.

1 2 3 4 5 6 7 8

g DEH41081 Installation Instructions R02 A Series®Lighting Control Panelboards Introduction These instructions describe the installation of a AE

2. Locate the interior end flange keyhole mounting holes to the corresponding mounting bolts already in place on the inside surface of the panel enc

Page 3

3. Remove dead front shield in preparation of wiring the line and branch breakers of the interior. Keep mounting screws handy for re-assembly. Se

Page 4

Breaker Installation Procedure: 1. Make sure that all power supplying this equipment is disconnected before working. 2. Remove panel front and

Accessories Description Catalog No Handheld Programmer w. Connection Wire ASRGLCHPK Remote Switch Module ASRGLCDSK Daylight Optimizatio

Page 6

External Controller Installation Instructions: 1. Connect one end on the control cable to DB25 connector on back plane first and other end of thec

These instructions do not cover all details or variations in equipment nor do they provide for every po

Page 8

- 8 -

Pas de commentaire

Ge-industrial-solutions A Series Lighting Control Panelboards Installation Manuel d'utilisateur